Renovation DIY: How to Avoid Tiles After Shedding

In order to cater to the consumers who are pursuing new trends, some new technological methods have emerged in the market, such as tile adhesives, colorful caulking agents, leaving seams, and the like. Tile adhesive (also called dry stick method), tiles do not need to be pre-soaked in the base surface without wet, as long as the basis of the pavement can be better, so that the status of the work has been greatly improved.

Renovation DIY: How to Avoid Tiles After Shedding

Do-it-yourself decoration just needs to pay attention to the following four aspects in the decoration process:

1, clean up the base level before tiling

If the wall has lime plaster, latex paint, wallpaper and other decorative objects, or dirt on the ground, be sure to clean, otherwise the cement mortar and the grass-roots bond is not strong; In addition, if the wall itself has cracks, should do properly After processing, tiles can be used to prevent cracks or cracks in the wall bricks from increasing the cracks in the basic structure in the future. Also, for the ground and wall surfaces where the flatness or verticality gap is too large, cement mortar should be used for leveling treatment. The difference in the color of the tiles is also compared before the shop.

2, Paving tiles must first be laid flat

Laying non-cemented floor tiles on the ground, knocking them out, spreading the grout to the floor tiles, and laying them on the ground, with the four bricks flush in the diagonal position. The laying of the order is also stress. Posted floor tiles should be posted from the inside, such as the ground slope or floor drain, should pay attention to find the slope by the drainage direction; wall tiles should be laid up from the bottom, for the sake of beauty, the bottom of the brick should be posted. After pressing the tiles, press the tiles. In addition, a wall cannot be attached to the top at a time to prevent the tile from being heavy and causing it to fall. Do not step on tiles for a short period of time.

3, brick wall should be fully submerged

Because wall tiles have a high moisture content, this feature must be considered when pasting. Before the tiling, the base layer should be fully watered and wet; otherwise, the moisture in the mortar will be rapidly absorbed by the dried base and tiles, and will quickly condense, which will affect its adhesive fastness. Otherwise, the tiles will absorb moisture from the cement so that the cement cannot function as an adhesive.

4, tiles as much as bubble

In the summer, because the material is drier than ordinary, so for the tiles, tiles and other materials that need to be treated with swelled water, the treatment time of the swelled water should be prolonged to bring the moisture to saturation. In this way, the phenomenon of water absorption from the cement due to the drying of the tiles due to the drying of the tiles will not occur, and the cement will not be firmly bonded to the tiles, causing hollowing and falling off, and will bring you some unnecessary troubles.

In order to cater to the consumers who are pursuing new trends, some new technological methods have emerged in the market, such as tile adhesives, colorful caulking agents, leaving seams, and the like. Tile adhesive (also called dry stick method), tiles do not need to be pre-soaked in the base surface without wet, as long as the basis of the pavement can be better, so that the status of the work has been greatly improved.

Tiles, floor tiles, cement, latex paint, wallpaper, decorative paint, floor tile, tile adhesive

Silicon Calcium Barium Alloy

Silicon Calcium Barium Alloy,High Quality Silicon Calcium Barium Alloy,Silicon Calcium Barium Alloy Details, Anyang Penghang Metallurgical Refractory Co., Ltd.

Ningxia Xinshuncheng Special Alloy Co., Ltd. , http://www.xinshunchengalloy.com